Table of Contents
Advertisement
Stratasys J850/J835 User Guide
3. Make sure that the build tray is empty, and confirm this in the wizard
4. Select the UV lamp(s) to be replaced and click Next.
5. Disconnect the UV-lamp power connector and the UV heat fuse connector.
DOC-18001 Rev. N
screen. Then, close the printer, and click Next.
Figure 4-175 Tray confirmation
The axes move to the "home" position.
Figure 4-176 UV lamp selection screen
Figure 4-177 Disconnecting the UV lamp
4 Operating and Maintaining the Printer
4-114
Advertisement
Table of Contents
