Table of Contents
Advertisement
Stratasys J850/J835 User Guide
4. After selecting the materials for the appropriate cartridge slots, the
Additional Flushing Cycles
The flushing cycle you select in the Material Replacement Options screen
determines how thoroughly to flush out material currently in the system. After
selecting the Economy cycle and completing the wizard, you might decide that
you require a more thorough flushing, to ensure accurate colors. Or, you may
notice that the 3D prints are not satisfactory because they contain traces of the
previous material. If so, you can flush out more material, so that the next print
job will be printed with pure material.
To perform additional flushing cycles:
➢ In the Advanced Settings screen, select Enable "flush again" options
The Material Replacement Options screen appears, where you can select the
material(s) you need to flush again.
DOC-18001 Rev. N
Cartridge Positioning screen appears. Place the cartridges in the materials
cabinet as shown in this screen.
Figure 4-48 Cartridge Positioning screen (High Speed mode)
and click Apply.
Figure 4-49 Enable flush again options selected
4 Operating and Maintaining the Printer
4-34
Advertisement
Table of Contents
