Table of Contents
Advertisement
Stratasys J850/J835 User Guide
12. Click Next to display the next head alignment screen, and again select the
13. Continue as follows:
14. In the following screen, you can choose to either repeat the head alignment
DOC-18001 Rev. N
number representing the most closely aligned vertical lines on the
transparency for that print head.
When you have finished aligning all of the heads, the following screen is
displayed.
Figure 4-93 Parameter update confirmation
❒ To make the alignment changes in the printer, make sure that Update
system with new parameters is selected, and click Next.
A message that the parameters were updated appears. For all modes,
except High Quality, since the update to parameters can affect the color
uniformity, it is recommended to continue directly with the Color
Uniformity wizard.
❒ To recheck the alignment test results before making the alignment
changes in the printer, click Previous.
❒ If you do not want to make alignment changes in the printer at this time,
select Keep previous parameters, and click Next.
procedure, continue to the Color Uniformity wizard, or close the wizard.
Figure 4-94 Repeat head alignment option
❒ If the most closely aligned vertical lines for a print head were at either
extreme, choose Repeat the test, then click Next.
4 Operating and Maintaining the Printer
4-64
Advertisement
Table of Contents
