Table of Contents
Advertisement
Stratasys J850/J835 User Guide
The waste container consists of a plastic container inside a cardboard box.
You typically dispose of the entire waste container—including the box.
Therefore, you must assemble a new box and insert a new plastic container
before you can install it in the printer.
Replacement boxes, plastic containers, and sealing caps are supplied in
the printer start-up kit and in the preventive-maintenance kit.
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
2. Place a new plastic container into the box.
3. Close the new waste container box.
Caution:
Do not replace the waste container box during a printing job. Waste
container replacement during printing might cause the printing process to
stop or a severe print failure.
To replace the waste container:
1. Locate the door on the lower-left side of the printer.
2. Push in the top-center of the door to release the latch and open the door.
3. Carefully slide out the waste container to remove it from the printer.
4. Place the new waste container next to the full container.
5. Unscrew the cap securing the waste drain tube and connect it to the new
6. Close the full container with the cap supplied with the new waste container.
DOC-18001 Rev. N
sections.
If necessary, use tape to hold it closed.
Figure 4-216 Accessing the waste container
container.
4 Operating and Maintaining the Printer
4-143
Advertisement
Table of Contents
