Table of Contents
Advertisement
Stratasys J850/J835 User Guide
15. Remove the clamp from the tube that is directed to the waste container
16. Connect the tubes to the new pump cassette.
17. Use the cleaning cloth to wipe the spilled material.
18. Perform the Pattern Test and make sure the pump cassette operates
19. If necessary, replace the pump cassette on the other waste pump.
20. Attach the panel to the printer.
21. Open the Maintenance Counters screen, scroll down to the General Pumps
DOC-18001 Rev. N
(pump outlet).
Figure 4-168 Clamp removed from the outlet side of the pump (sample)
Figure 4-169 Secured pump (sample)
properly. See "Pattern Test" on page 4-45.
Make sure to reconnect the ground wire to the printer panel.
section, and click Reset for the relevant counter(s) (see Figure 4-158 on
page 4-103).
4 Operating and Maintaining the Printer
4-109
Advertisement
Table of Contents
