Table of Contents
Advertisement
Stratasys J850/J835 User Guide
7. Verify that the build tray is clean, and close the cover. Confirm this in the
8. When done, click Next.
9. Select the action that you wish to perform.
DOC-18001 Rev. N
wizard screen and click Next.
Figure 4-7 Confirming tray is clean and cover is closed
A carpet is printed on the printable area of the tray (not all the way to the
edge of the tray). This may take up to 10 minutes.
Figure 4-8 Printing a carpet
Figure 4-9 Select Action to set fabric thickness or exit wizard
❒ To place double-sided adhesive tape on the carpet and then secure the
fabric on it, select Set fabric thickness and place fabric on tray and
click Next.
❒ If you do not wish to continue, select Exit wizard and click Next.
4 Operating and Maintaining the Printer
4-10
Advertisement
Table of Contents
