Stratasys J850/J835 User Guide
DOC-18001 Rev. N
The wizard operates the UV lamps and checks if their power is within the
acceptable range for each printing mode.
Note: The mode currently being checked appears in the lower-left corner
of the printer interface.
Figure 4-191 Status during UV lamp check
After replacing a UV lamp, it is recommended that you calibrate its power
for the various printing modes. The next screen allows you to continue to
the UV Calibration wizard (see "Testing and Calibrating the UV Lamps" on
page 4-86).
Figure 4-192 Calibration selection screen
4 Operating and Maintaining the Printer
4-121