Table of Contents
Advertisement
Stratasys J850/J835 User Guide
5. In the Required materials section of the wizard screen, select one or more
6. For model materials, select Both if you need to load two replacement
DOC-18001 Rev. N
3 Materials
Both sections of each print head are loaded with the same material.
Figure 4-37 Three materials loaded in the print heads
Up to three model materials are available, with high-speed printing.
Single Material
Both sections of two print heads are loaded with the same model material.
Both sections of two print heads are loaded with Support material.
Figure 4-38 One model material loaded in the print heads
This mode produces parts in Super High Speed mode, at a layer resolution
of 55 microns.
replacement materials cartridges.
cartridges.
Loading one replacement cartridge is more economical because it
potentially requires less flushing of material currently in the system.
However, when one cartridge is not sufficient, loading two cartridges
enables continuous printing until the print job is completed. When one
cartridge empties and the other one is being used, you can replace the
empty cartridge with a new one.
4 Operating and Maintaining the Printer
4-26
Advertisement
Table of Contents
