Table of Contents
Advertisement
Stratasys J850/J835 User Guide
10. Click Next to begin the material replacement process in the printer.
Symbols:
11. Replace material cartridges as necessary, according to the instructions in
12. Click Start.
13. Read the warning message, and click OK.
If you continue, you must complete the material replacement process
before you can produce 3D prints. To replace material cartridges at another
time, click Cancel. If you continue (by clicking OK) and you do not complete
the process, you will need to run the wizard again before producing 3D
prints.
14. In the final wizard screen, click Done.
15. Inspect the area around the purge unit and clean it, if necessary.
DOC-18001 Rev. N
The Cartridge Positioning screen appears, showing you the new location of
all cartridges in the material cabinet.
Figure 4-39 Cartridge placement
The correct cartridge is in this slot.
No cartridge (or the incorrect cartridge) is in this slot.
The cartridge in this slot has insufficient weight to complete the material
replacement process.
The expiration date of the cartridge in this slot has passed.
the wizard screen.
The printer-control application is automatically updated, and it restarts.
When it opens, the interface displays the new material(s).
The interface in the job preparation application is also updated, and it
displays the new material(s).
4 Operating and Maintaining the Printer
4-28
Advertisement
Table of Contents
