Table of Contents
Advertisement
Stratasys J850/J835 User Guide
Samples printed from certain model materials in this test might not be
completely cured. Because some of the material remains in liquid (or semi-
liquid) state, you cannot check for gaps in these samples. Do not be
concerned that liquid resin remains on and around these samples.
DOC-18001 Rev. N
❒ In the right sample shown above, there are only two gaps, which is
acceptable.
Many gaps in the sample indicates that many nozzles in the print head are
not functioning. This might indicate the need to replace the defective head.
In this case, consult with your Stratasys service provider.
4 Operating and Maintaining the Printer
4-135
Advertisement
Table of Contents
