Table of Contents
Advertisement
23.3.5 UM Configuration—[4-3] Service Settings—Custom
Service—Password
The below parameters are set for the Password Custom Service in the Custom Service Builder.
This service requires that callers enter a password, followed by "#". Each password is assigned an operation.
If a password is entered correctly, the caller is handled by the password's pre-programmed operation. The
prompt for this service can be recorded in the CS No. dialogue box.
Custom Service prompts can be recorded only in On-line mode.
Description
The information typed in this field is for reference only.
Value Range
Max. 32 characters
Feature Guide References
3.2.1.15 Custom Service
Menu Repeat Cycle (1-3)
Specifies the number of times the Custom Service menu message will be repeated to the caller.
Value Range
1–3 times
Feature Guide References
3.2.1.15 Custom Service
Wait for First Digit (0-10 s)
Specifies the length of time that the system waits for the caller to dial the first digit after a Custom Service menu
is played for the caller. If this time expires, the No DTMF Operation setting determines how the call is then
handled.
Value Range
1–10 s
Feature Guide References
3.2.1.15 Custom Service
Maximum Number of Invalid Entry (1-10)
Specifies the number of times an invalid password is entered before the operation assigned for
Failure is executed.
Value Range
1–10 times
23.3.5 UM Configuration—[4-3] Service Settings—Custom Service—Password
Entry
PC Programming Manual
767
Advertisement
Table of Contents
