Table of Contents
Advertisement
Switch CLIP of CO Line / Extension
Specifies the feature number used to send either the CLIP number of the trunk in use (subscriber's number)
or the extension to the network.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
PC Programming Manual References
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—CO Setting—
Number
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—CLIP—
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—CLIP—
Feature Guide References
4.1.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
MCID
Specifies the feature number used to ask the telephone company to trace a malicious call. This feature can
be used during a call or while hearing a reorder tone after the caller hangs up.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Feature Guide References
4.1.2.8 Malicious Call Identification (MCID)
ISDN-FWD (MSN) Set / Cancel / Confirm
Specifies the feature number used to set or cancel the FWD of incoming ISDN calls to an outside party using
the ISDN service of the telephone company (instead of the PBX), or confirm the FWD setting.
Extension users can set the FWD destination to the network on an MSN basis.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Feature Guide References
4.1.2.4 Call Forwarding (CF)—by ISDN (P-P)
Message Waiting Set / Cancel / Call Back
Specifies the feature number used to set or cancel Message Waiting, or call back the caller.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Subscriber
CLIP ID
CLIP ID
PC Programming Manual
389
Advertisement
Table of Contents
