Table of Contents
Advertisement
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
Value Range
0–600 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T304
Specifies the maximum time allowed between each digit on an outgoing call. Applies to overlap sending.
Value Range
0–3000 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T305
Specifies the maximum time that the PBX waits for a reply after sending the DISC (disconnection) message
to ISDN.
Value Range
0–3000 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T308
Specifies the maximum time that the PBX waits for a reply after receiving the Release message from ISDN.
Value Range
0–600 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T309
Specifies the length of time that the PBX tries to disconnect the data link, before disconnecting the call.
Value Range
0–3000 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T310
Specifies the maximum time that the PBX waits for a continuance message after receiving the Incoming Call
Proceeding message.
Value Range
0–3000 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T313
Specifies the maximum time that the PBX waits for a reply after sending the Connect message.
Value Range
0–600 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T316
Specifies the maximum time that the PBX waits for a reply after sending the Restart message.
312
PC Programming Manual
Advertisement
Table of Contents
