Table of Contents
Advertisement
9.21 PBX Configuration—[1-1]
Configuration—Slot—Extension—Card Property
The property for the extension cards can be specified.
SLT Pulse Dial Mode
Selects the type of pulse dial transmission appropriate to your area.
Value Range
Normal, Sweden, New Zealand
SLT Off Hook Time
Specifies the minimum length that a pulse dial sent from an SLT must be for the PBX to recognise it as an
off-hook signal.
Value Range
8 ´ n (n=3–255) ms
SLT Off Hook Guard Time
Specifies the length of guard time used for off-hook signals from SLTs, to prevent the PBX mistaking them for
pulse dials.
Value Range
8 ´ n (n=12–63) ms
SLT Pulse Maximum Break Width
Specifies the maximum length of the break signal in a pulse dial.
Value Range
8 ´ n (n=9–20) ms
SLT Pulse Minimum Make Width
Specifies the minimum length of the make signal in a pulse dial.
Value Range
8 ´ n (n=1–5) ms
SLT Flash Detection
Enables the PBX to detect the flash signal sent when an SLT user presses the hookswitch or the Flash/Recall
button.
Value Range
Disable: The PBX disconnects the line to prevent placing the call on hold.
Enable: The PBX places the call on consultation hold.
9.21 PBX Configuration—[1-1] Configuration—Slot—Extension—Card Property
PC Programming Manual
295
Advertisement
Table of Contents
