Panasonic KX-NS300CN Pc Programming Manual page 673

VM Trunk Group No.
Specifies the number of the VM trunk group sent to the VPS when the incoming call destination is the floating
extension number of a VM (DPT) Group. The VM trunk group number is used to allow the VPS to send the
applicable greeting message to the caller.
Value Range
1–48
CLI for DIL
When CLI distribution is enabled for a trunk to which DIL distribution is set, incoming trunk calls will be
distributed to the CLI destinations (instead of the DIL destinations) if the caller's identification number is found
in the System Speed Dialling Table.
CLI distribution can be enabled or disabled for each time mode (day/lunch/break/night) on a trunk basis.
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Card Type
Indicates the trunk card type (reference only).
Value Range
Card type
Feature Guide References
2.1.1.1 Incoming Trunk Call Features—SUMMARY
Trunk Property
Indicates the networking type of each trunk (reference only).
Value Range
Public, Private(TIE), VPN
Feature Guide References
2.1.1.1 Incoming Trunk Call Features—SUMMARY
4.2.1 TIE Line Service
4.2.3 ISDN Virtual Private Network (ISDN-VPN)
Distribution Method
Selects the distribution method for incoming trunk calls. The value range of this setting depends on the card
type and Trunk Property assigned for each trunk.
Value Range
DIL: Distribution depends on the trunk through which the calls arrive
DDI/DID: Distribution depends on the DDI/DID number of the calls
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
PC Programming Manual 673