Table of Contents
Advertisement
9.25 PBX Configuration—[1-1]
Configuration—Slot—Card Property - PRI type
The properties of the PRI card can be specified.
ISDN CO / QSIG Master / QSIG Slave—T200
Specifies the maximum time that the PBX waits for a reply after sending the L2 command to ISDN.
Value Range
0–600 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T202
Specifies the maximum time that the PBX waits for a reply after resending the request to use an ISDN line as
a TIE line.
Value Range
0–600 ´ 100 ms
Feature Guide References
4.2.1 TIE Line Service
ISDN CO / QSIG Master / QSIG Slave—T203
Specifies the length of time to detect no communication status of L2.
Value Range
0–600 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T301
Specifies the maximum time that the PBX waits for a reply after making a call to ISDN.
Value Range
0–18000 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T302
Specifies the maximum time allowed between each digit on an incoming call. Applies to overlap receiving.
Value Range
0–600 ´ 100 ms
ISDN CO / QSIG Master / QSIG Slave—T303
Specifies the maximum time that the PBX waits for a reply after sending the SETUP (call setting) message to
ISDN.
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
PC Programming Manual
311
Advertisement
Table of Contents
