Table of Contents
Advertisement
1.2.1 Starting Web Maintenance Console
Hard Disk
Copyright for MD5
This software uses the Source Code of RSA Data Security, Inc. described in the RFC1321 (MD5
Message-Digest Algorithm).
Copyright (C) 1991-2, RSA Data Security, Inc. Created 1991. All rights reserved.
Licence to copy and use this software is granted provided that it is identified as the "RSA Data Security, Inc.
MD5 Message-Digest Algorithm" in all material mentioning or referencing this software or this function.
Licence is also granted to make and use derivative works provided that such works are identified as "derived
from the RSA Data Security, Inc. MD5 Message-Digest Algorithm" in all material mentioning or referencing the
derived work.
RSA Data Security, Inc. makes no representations concerning either the merchantability of this software or
the suitability of this software for any particular purpose. It is provided "as is" without express or implied warranty
of any kind.
These notices must be retained in any copies of any part of this documentation and/or software.
PC Connection (On-line Mode)
To connect to Web Maintenance Console in On-line mode, both the PC and the PBX must be connected. The
connection can be made through a local area network (LAN), a virtual private network (VPN), or over the
Internet. A PC can also be connected directly to the maintenance port of the PBX.
Connecting to Web Maintenance Console (On-line Mode)
Below is the procedure for connecting to Web Maintenance Console to programme in On-line mode:
1.
Connect the PC to the PBX:
•
Connect the PBX to a network with the LAN port and access the PBX from a PC in your LAN or VPN.
•
Connect the PBX to a network with the LAN port and access the PBX from a PC using an Internet
connection.
2.
Access Web Maintenance Console:
LAN or VPN connection:
Launch your Web browser and input the IP address of the PBX followed by the Web Maintenance Console
port number into the address bar. The input method will differ according to the PC's connection to the PBX.
The default IP address for the LAN port of the PBX is 192.168.0.101, and the default Web Maintenance
Console port number is 80. Accordingly, the address to enter to connect to the PBX for the first time will
be as follows (enter the address exactly as shown):
http://192.168.0.101
MNT Port connection:
Launch your Web browser and in the address bar, enter one of the following addresses exactly as shown:
– 223.0.0.1
or
– http://kx-ns300.
22
PC Programming Manual
Recommended Specification
10 GB available space
Advertisement
Table of Contents
