Power Supply Warnings And Cautions; Installing The Atx 550W Non-Hot-Plug Power Supply - HPE ProLiant ML110 User Manual

Table of Contents

Advertisement

Power supply warnings and cautions

WARNING: To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
Unplug the power cord from the power supply to disconnect power to the equipment.
Do not route the power cord where it can be walked on or pinched by items placed against it. Pay
particular attention to the plug, electrical outlet, and the point where the cord extends from the
server.
WARNING: To reduce the risk of injury from electric shock hazards, do not open power supplies. Refer
all maintenance, upgrades, and servicing to qualified personnel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning
any installation procedure. Improper grounding can cause electrostatic discharge.
CAUTION: Mixing different types of power supplies in the same server might:
Limit or disable some power supply features including support for power redundancy.
Cause the system to become unstable and might shut down.
To ensure access to all available features, all power supplies in the same server should have the same
output and efficiency ratings. Verify that all power supplies have the same part number and label color.

Installing the ATX 550W non-hot-plug power supply

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
ATX 550W non-hot-plug power supply
T-15 Torx screwdriver
Procedure
1.
Power down the server on page 23.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Hardware options installation
57

Advertisement

Table of Contents
loading

Table of Contents