Terminating The Engineering Mode - Toho Electronics TRM-10C Instruction Manual

Example) When setting the terminal temperature for Channel 1.
Display
[Note]
When calibrate the terminal temperature, select a channel to calibrate for channel 1 to channel 3, and select
another channel for channel 4 to channel 6. Calibrate these channels separately.

7.3 Terminating the Engineering Mode

Example) The following describes how to save the setting data.
Display
[Note]
1)
Upon termination, if you select "
" ", the settings will become invalid. Selecting "
recording under the previous settings.
Operation keys
Enter the engineering mode (See the key operation
ENT
in page 69). Use the △ key to display
ENT
PRINT
"
Use the △ key to select "
ENT
PRINT
"ENT" key.
Select the Channel to set, and press the "ENT" key.
PRINT ENT
Measure and display the real time terminal
temperature. When press the "ENT" key, turn to
ENT
the setting temperature display.
Use the △ key to alter a numeral, and
PRINT
FEED
a digit. Then, press the "ENT" key. See 9.5 (3)
ENT
Calibration of Reference Junction Compensation.
If the calibration is correct, select "
the △ key, and if incorrect, select "
PRINT ENT
respectively. Then, press the "ENT" key.
Operation keys
Use the △ key to display "
ENT
PRINT
"ENT" key.
Use the △ key to select "
ENT
"ENT" key. The settings of the engineering mode
have been saved. Recording starts under the new
settings.
" and turn off the power without selecting
―84―
Description
", and press the "ENT" key.
", and press the
Description
", and press the
" invalidates the settings and starts
HXPRM10mnCT001E
key to shift
" with
",
", and press the