Terminating The Engineering Mode - Toho Electronics TRM-10C Instruction Manual

Hybrid pen type recorder
Hide thumbs Also See for TRM-10C:
Table of Contents

Advertisement

Example)
Display

7.3 Terminating the Engineering Mode

Example)
Display
[Note]
1)
Upon termination, if you select "
settings will become invalid. Selecting "
under the previous settings.
When setting the terminal temperature for Channel 1
Operation Keys
ENT
ENT
PRINT
ENT
PRINT
PRINT
ENT
ENT
PRINT
FEED
ENT
PRINT
ENT
The following describes how to save the setting data.
Operation Keys
ENT
PRINT
ENT
" and turn off the power without selecting "
―94―
Description
Enter the engineering mode (See the key operation
in page 78). Use the △ key to indicate "
", and press the "ENT" key.
Use the △ key to select "
"ENT" key.
Select the Channel to set, and press the "ENT" key.
Measuring and indicating the real time terminal
temperature. When pressing the "ENT" key, turn to
the setting temperature display.
Use the △ key to alter a numeral, and
a digit. Then, press the "ENT" key.
See the section 9.5
Junction Compensation" in page 99.
If the calibration is correct, select "
the △ key, and if incorrect, select "
respectively. Then, press the ENT key.
Description
Use the △ key to display "
"ENT" key.
Use the △ key to select "
"ENT" key. The settings of the engineering mode
have been saved. Recording starts under the new
settings.
" invalidates the settings and starts recording
", and press the
key to shift
"Calibration of Reference
" with
", and press the
", and press the
", the
HXPRM10mnCT002E
",

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRM-10C and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents