Setting The Engineering Mode - Toho Electronics TRM-10C Instruction Manual

7.2 Setting the Engineering Mode

Key Operation to Enter the Engineering Mode
Hold down the "MENU" key for 3 seconds or more to enter the setup mode.
Use the △ key to select "
Use the △ key to alter a numeral, and the
Press the "ENT" key then to display blinking "
Press the "ENT" key. After reset, enter the engineering mode.
The following describes how to set the following items.
The following shows a display map of the Enginneering mode. Use the △key to operate.
⚫
7.2.1 Alarm Hysteresis
Setting
⚫
7.2.2 Burnout ON/OFF
Setting
⚫
7.2.3 Channel Offset
Setting
⚫
7.2.4 Reference Junction Compensation
Setting
", and press the "ENT" key then to display "0000".
ON/OFF
Set the hysteresis width
Cancel the hysteresis width
Channel ON/OFF
Channel OFFSET
Channel Function
―69―
key to shift a digit, enter the password "2222".
".
Set burnout
Cancel burnout
Enter an offset value
ue
Internal Compensation
External Compensation
Channel Input Compensation
HXPRM10mnCT001E