Toho Electronics TRM-10C Instruction Manual page 72

⚫
7.2.11 Point Calibration
Setting Function
⚫
7.2.12 Data Calibration
Setting Function
⚫
7.3 Terminating the Engineering Mode
Setting Function
［Note］
Upon termination if you select "
become invalid. For "
Table 7.3 Initial setting value of the engineering mode
Setting items
★Alarm hysteresis
★Burnout (all channels)
★Channel offset (all channels)
★RJC (all channels)
★Dot print color (1～6channel)
★RUN record
RUN/STOP trigger
Channel/Tag print
Alarm print
Logging print
Logging printing interval
Logging print reference time
Scale print
Logging print Sync/Async
Record Start/end print
★COM (communication)
Protocol
Address
Baud rate
Data length
Parity bit
Stop bit
★DI (1～3 channel)
★Temperature unit
Zero point calibration
Span point calibration
Hysteresis at left/right move
Ribbon select calibration
Ribbon select calibration 2
Voltage calibration
Resistance temperature detector calibration
Internal reference junction compensation calibration
Save a set value
Cancel a set value
" and turn off the power without executing "
" operation, see Page 84.
ON(0.5%)
OFF
0.0
Internal compensation INT
Purple(1), Red(2), Green(3), Blue(4),
Brown(5), Black(6)
INT
Ch
OFF
ON
6H
00:00
OFF
Sync print
OFF
Original
01
9600
8bit
None
1bit
OFF
Centigrade Unit
―71―
Initial set
", the setting will
Remarks
Use the
RUN key
HXPRM10mnCT001E