Initializing The Setup Data; Di Functions - Toho Electronics TRM-10C Instruction Manual

7.2.8 Initializing the Setup Data and Calibration Data
When you select the "
When you select the "
In addition, setup mode settings are not initialized. Operation Please consult with care.
Example) When you initialize the Setup Data.
Display
．

7.2.9 DI Functions

Allocate the functions to three DIs. There are the following 12 DI functions.
No function
Manual print (Sync.)
Manual Print (Async.)
RUN/STOP trigger function
Date/Time Print (Sync.)
Date/Time Print (Async.)
Chart speed selection
Comment print 1-3 (Sync.)
Comment print 1-3 (Async.)
Example) When setting comment prints 3 for DI3.
Display
［Note］
The setting is OFF without the DI option. Do not set any setting except for OFF.
", the setup mode settings is all initialized.
", is reset to the factory default calibration value.
Operation keys
ENT
Enter the engineering mode (See the key operation
in page 69). Use the △ key to display "
ENT
PRINT
and press the "ENT" key.
Use the △ key to select "
ENT
PRINT
"ENT" key.
Initialization is completed.
:
: (Positive edge: running start)
: (Positive edge: running start)
: (ON:RUN, OFF:STOP)
: (Positive edge: running start)
: (Positive edge: running start)
: (ON:Spd-1, OFF:Spd-2)
､ ､
:
､ ､
:
Operation keys
Enter the engineering mode (See the key operation
ENT
in page 69). Use the △ key to display
ENT
PRINT
"
Use the △ key to select "
ENT
PRINT
"ENT" key.
Use the △ key to display "
PRINT ENT
the "ENT" key.
Setting is completed. Returned to the DI3 Function
Setting screen.
―79―
Description
(Positive edge: running start)
(Positive edge: running start)
Description
", and press the "ENT" key.
",
", and press the
", and press the
", and press
HXPRM10mnCT001E