Initializing The Setup Data; Di Functions - Toho Electronics TRM-10C Instruction Manual

7.2.8 Initializing the Setup Data

When you select the "
When you select the "
In addition, setup mode settings are not initialized. Operation Please consult with care.
Example) When you initialize the Setup Data.
Display
．

7.2.9 DI Functions

Allocate the functions to three DIs. There are the following 12 DI functions.
No function
Manual print (Sync.)
Manual print (ASync.)
RUN/STOP trigger function
Date/time print (Sync.)
Date/time print (ASync.)
Chart speed selection
Comment print 1-3 (Sync.)
Comment print 1-3 (ASync.)
Example) When setting comment prints 3 for DI3
Display
［Note］
① Although "DI synchronous print" is not printed in RUN OFF, "DI asynchronous print" prints also
in RUN OFF.
② The setting is OFF without the DI option. Do not set any setting except for OFF.
", the setup mode settings is all initialized.
", is reset to the factory default calibration value.
Operation Keys
Enter the engineering mode (See the key operation
ENT
in page 78). Use the △ key to indicate
ENT
PRINT
"
Use the △ key to select "
ENT
PRINT
"ENT" key.
Initialization is completed.
ENT
PRINT
:
: (Positive edge: running start)
: (Positive edge: running start)
: (ON:RUN, OFF:STOP)
: (Positive edge: running start)
: (Positive edge: running start)
: (ON:Spd-1, OFF:Spd-2)
:
:
Operation Keys
Enter the engineering mode (See the key operation
ENT
in page 78). Use the △ key to indicate "
ENT
PRINT
press the "ENT" key.
Use the △ key to select "
ENT
PRINT
"ENT" key.
Use the △ key to indicate "
PRINT ENT
the "ENT" key.
Setting is completed. Returned to the DI3 Function
Setting screen.
―89―
Description
", and press the "ENT" key.
(Positive edge: running start)
(Positive edge: running start)
Description
HXPRM10mnCT002E
", and press the
", and
", and press the
", and press