Optimizing The Integrator Zoom And Focus - Christie Roadie D4K40-RGB Installation And Setup Manual

6. To focus the right boresight guide, adjust the green boresight screw.
7. To focus the left boresight guide, adjust the yellow boresight screw.
8. To continue to refine the focus, repeat steps 5 to 7.
9. Before adjusting the stabilization screws, close the shutter.
10. To maintain the adjustments, lock the stabilization screws.
When locking the screws, start with the top stabilization screw and turn it so it just touches the
base. Repeat for the other two stabilization screws. Continue to adjust the locking screws until
they are tight.
11. Open the shutter.

Optimizing the integrator zoom and focus

Learn how to optimize the integrator zoom and focus.
1. From the Test Pattern menu, select the Integrator Rod test pattern.
2. Open the Service door on the side of the projector.
D4K40-RGB Installation and Setup Guide
020-102961-06 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
33