Keyless Start System Operation Inspection; Door Lock Operation Check (Keyless Start System) - Suzuki Grand Vitara 2011 Manual

Keyless Start System Operation Inspection

Keyless Engine Start Operation
1) Sit in driver seat with remote controller carried with
you.
2) Check that all doors are closed and ignition key is
not inserted in ignition key cylinder.
3) While pushing ignition knob switch (1) of steering
lock unit, check if ignition knob switch can be turned
from its lock position.
If key indicator light (2) in combination meter lights in
blue and ignition knob switch can be turned from its
lock position in this check, keyless engine start
operation is in good condition.
If key indicator light in combination meter lights in red
and ignition knob switch cannot be turned from its
lock position in this check, go to "Keyless Start
System Check".
NOTE
Pushing ignition knob switch for 5 seconds
or longer causes function to protect steering
lock releasing solenoid against heat to work.
Then steering lock unit stops energizing
solenoid, preventing ignition knob switch
from turning. At the same time, key indicator
light in combination meter turns off. In such
case, take your hand off from ignition knob
switch once and operate it again.
S6JB0AA504011
2
1
I5JB0AA50010-01
Keyless Start System:
Door Lock Operation Check (Keyless Start
System)
1) Check that all door locks are released and all doors
are closed.
2) With remote controller of which ID code is registered
in keyless start control module carried with yourself,
check that pushing driver door, passenger door or
rear end door request switch once locks all doors.
3) Check door unlock operation as follows.
a) Door lock 1-Action type, check that pushing
request switch of driver door, passenger door or
rear end door once releases all door locks.
b) Door lock 2-Action type, check that pushing
request switch of driver door, passenger door or
rear end door once releases corresponding door
lock.
4) Door lock 1-Action type, check that pushing again
request switch pushed in Step 3) releases all door
locks.
NOTE
If door of which request switch has been
pushed is opened/closed before performing
Step 4), all door locks will not be released
even when Step 4) is performed. If Step 4) is
performed after door is opened/closed, only
the door of which request switch was pushed
will be locked.
10E-15
S6JB0AA504012
I5JB0AA50011-01