Suzuki Grand Vitara 2011 Manual page 2169

DTC P1616: Unregistered Keyless Start Control Module (for Vehicle with Keyless Start System)
Wiring Diagram
Refer to "Immobilizer Control System Wiring Circuit Diagram: For Petrol Engine Model"
Circuit Description
P1616 is detected when ECM detects different ID codes registered in ECM and keyless control module after turning
engine start knob to ON position. Normally, when keyless start control module is replaced with new one, ECM
automatically registers the applicable code in keyless start control module after turning ignition switch to ON position.
However, when keyless start control module is replaced with used one, ECM does not automatically register the
applicable code in keyless start control module even if ignition switch is turned to ON position.
Detecting Condition and Trouble Area
Detecting Condition
ECM detects different ID codes registered in ECM and
keyless control module.
Troubleshooting
Step
1 Diagnostic Trouble Code (DTC) confirmation
1) Clear DTC(s) referring to "Diagnostic Trouble Code
(DTC) Clearance: For Petrol Engine Model".
2) Turn the ignition switch to OFF position.
3) Check if any DTC is detected referring to "Diagnostic
Trouble Code (DTC) Table: For Petrol Engine Model".
Is DTC P1616 still detected?
2 Registration of the ignition key
1) Clear DTC referring to "Diagnostic Trouble Code (DTC)
Clearance: For Petrol Engine Model".
2) Register the transponder code in the transponder in the
ignition key with ECM referring to "Registration of the
Ignition Key: For Petrol Engine Model".
Was it possible to register the ignition key (transponder
code) in ECM?
3 Keyless start system operation check
1) Start engine using keyless start system.
Does engine start?
4 Diagnostic Trouble Code (DTC) check
1) Check ECM for DTC referring to "Diagnostic Trouble
Code (DTC) Check: For Petrol Engine Model".
Are DTC P1618 and/or P1615 detected other than P1616?
Immobilizer Control System: For Petrol Engine Model 10C-14
Action
Trouble Area
• Keyless start control unit faulty
• ECM faulty
Yes
Go to Step 2.
Go to Step 3.
The troubleshooting is
completed.
Go to DTC P1618
troubleshooting.
S6JB0AA314010
No
The troubleshooting is
completed.
Go to Step 4.
Check if any DTC is
detected by ECM. If
detected, perform the
troubleshooting
referring to the
corresponding
flowchart.
Go to DTC P1615
troubleshooting.