9C-24 Instrumentation / Driver Info. / Horn:
Horn Inspection
1) Disconnect negative (–) cable at battery.
2) Remove front bumper referring to "Front Bumper
Components in Section 9K".
3) Disconnect horn connector (1).
4) Connect battery positive (+) to terminal of horn
connector (2) and negative (–) terminal to body
ground.
If horn is not sounding, replace horn.
2
1
Horn Relay Inspection
1) Disconnect negative (–) cable at battery.
2) Remove horn relay (included in integration relay) (1)
from main fuse box (2).
S6JB0A9306022
1
2
I5JB0A930024-01
S6JB0A9306023
1
I5JB0A950031-01
3) Check that there is no continuity between terminal
"a" and "b".
If there is continuity, replace relay.
4) Check that there is continuity between terminals "a"
and "b" when a 12 V battery is connected to terminal
"a" and "c".
If malfunction is found, replace integration relay.
"a"
"b"
"a"
"b"
Antenna Base Removal and Installation
Removal
1) Remove antenna (1) from antenna base (2).
2) Remove head lining referring to "Head Lining
Removal and Installation in Section 9H".
3) Disconnect antenna feeder (3) from antenna base
(2).
4) Remove antenna base (2) from vehicle.
Installation
Reverse removal procedure noting the following.
• Tighten antenna base mounting nut to specified
torque.
Tightening torque
Antenna base mounting nut (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
"c"
"c"
I5JB0A930025-03
S6JB0A9306024
1
2
(a)
I4RH01930009-01