Headlight Aiming Adjustment With Screen - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:

Table of Contents

Headlight Aiming Adjustment with Screen

• Unless otherwise obligated by local regulations, adjust headlight aiming according to the following

• After replacing headlight housing, be sure to adjust aiming.

• When inspecting and adjusting headlight with leveling system, make sure to set the leveling switch

to "0" position with ignition switch turned ON.

1) Make sure the following items.

• Place vehicle on a flat surface in front of blank wall (screen) (1) ahead of headlight surface.

Distance "a"

10 m (32.8 ft.)

• Adjust air pressure of all tires to the specified value respectively.

• Bounce vehicle body up and down by hand to stabilize suspension.

• Carry out aiming with a driver aboard.

Driver's weight

75 kg (165 lb)

2) Check to see if hot spot (high intensity zone) of each low beam axis falls as shown in figure.

If the headlights interfere each other and make it hard to see the cut line clearly, cover the headlight on

one side. This helps to make aiming adjustment easier.

Hot spot specification

Angle "b": 0.75° (Specification)

Calculated distance "H": Approx. 130 mm (5.15 in.)

Lighting Systems:

S6JB0A9206005

Table of Contents