Rear End Door Window Defogger Wire Repair; Power Window Main Switch Inspection - Suzuki Grand Vitara 2011 Manual

4) Touch voltmeter negative (–) lead to defogger wire
ground terminal end (1).
5) Touch voltmeter positive (+) lead with a foil strip to
defogger wire power source terminal end (2), then
move it along wire to defogger wire ground terminal
end (1).
The place where voltmeter fluctuates from 10 – 12 V
to 0 – 1 V is where there is open.
If found defective, repair defogger wire referring to

"Rear End Door Window Defogger Wire Repair".

2
Rear End Door Window Defogger Wire Repair
1) Use white gasoline for cleaning.
2) Apply masking tape (1) at both upper and lower
sides of heat wire (2) to be repaired.
3) Apply commercially-available repair agent (3) with a
fine-tip brush (4).
4) 2 to 3 minutes later, remove masking tapes (1).
5) Leave repaired heat wire as it is for at least 24 hours
before operating the defogger again.

Power Window Main Switch Inspection

Switch for driver side window
1) Remove driver side door trim referring to step 1) to
3) of "Front Door Glass Removal and Installation".
2) Remove power window main switch from door trim.
3) Connect 12 V battery positive (+) terminal to terminal
"IG" of power window main switch and its negative (–
) terminal to terminal "E" of power window main
switch.
4) Check for continuity between terminals as shown
below.
If check result is not as specified, replace power
window main switch.
1
I5JB0A950034-01
S6JB0A9506015
I2RH01950005-01
S6JB0A9506016
Glass / Windows / Mirrors:
[A]: LH steering vehicle
[B]: RH steering vehicle
9E-20
I5JB0A950035-03