Ethernet Communication; Communication Ethernet; Protocol Modbus Tcp And Modbus Tcp/Rtu Gateway - Siemens SICAM Q100 7KG95 Series Manual

Operational Indications and Operating Parameters
15.2 Basic Functions
Parameter
Current inverse Ib
Current inverse Ic
Current inverse IN

Ethernet Communication

15.2.4
15.2.4.1

Communication Ethernet

Table 15-5
Parameter
Communication Ethernet
55
IP address
Subnet mask 55
Default gateway
Ethernet switch on
Enable SNMP
Bus protocol
NOTE
i
i
If you select Both for Bus protocol, Modbus TCP and IEC 61850 work in parallel.
15.2.4.2

Protocol Modbus TCP and Modbus TCP/RTU Gateway

Table 15-6
Parameter
Standard port number
Access rights
User-defined port 1
56
Port number
Access rights 56
After the parameter changes have been enabled, the device will reset.
55
56 This parameter is available only if User-defined port 1 is set to yes.
348
Default Setting
No
54
No
54
No
54
Settings for Communication Ethernet
Default Setting
192.168.0.55
255.255.255.0
192.168.0.1
55
No
No
Modbus TCP
Settings for Modbus TCP
Default Setting
502
Full
No
503
Read only
Setting Range
No
Yes
No
Yes
No
Yes
Setting Range
Any
0.0.0.0 = DHCP
Any
Any
No
Yes
No
Yes
-None-
Modbus TCP
IEC 61850
Both
Setting Range
502
Not settable
Full
Read only
No
Yes
503 to 65 535
Full
Read only
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A9, Edition 06.2021