3.2.4.2
Configuration and Value View via the User Interface
Configuration of the Flicker
To configure the Flicker lamp model in the Configuration tab, proceed as follows:
•
In the navigation window, click AC measurement.
[sc_Q100_flicker lamp model, 3, en_US]
Figure 3-21
•
Select a Flicker lamp model according to the following table.
The Flicker lamp model selection depends on the Primary nominal voltage, because flicker is a visual
phenomenon created by voltage variations, and the voltage variations are caused by changing in lumi-
nance of lighting systems.
Table 3-13
Parameter
Flicker lamp model
•
After the parameterization, click Send.
•
In the navigation window, click Activation and cancel.
•
Click Activation.
Value View of the Flicker
To display the flicker values in the Value view tab, proceed as follows:
•
In the navigation window, click Flicker.
To display the aggregation values of the flicker in the Value view tab, proceed as follows:
•
In the navigation window, click Records.
•
Configure the respective parameters according to
face.
•
Select Long term flicker or Short term flicker as the Measurement source.
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A9, Edition 06.2021
Configuration Tab, Flicker
Settings for Flicker
Default Setting
230 V
3.2 Measurement and Evaluation Functions
Setting Options
230 V
120 V
7.8.2 Configuration and Value View via the User Inter-
Measuring and Recording
117