Siemens SICAM Q100 7KG95 Series Manual page 281

•
Insert the device into the assembly opening until it hits the limit and keep holding it tightly.
•
Attach the 2 mounting elements (included with the device) on both sides of the case. You have the possi-
bility to attach the mounting elements as follows:
[dw_assembly, 1, en_US]
Figure 11-2
(1)
(2)
•
Swing the mounting element over the rear cone to the position.
•
Use a screw driver (0.6 mm x 4.5 mm) to fix the mounting elements until the slipping clutch takes effect.
NOTE
i i
The mounting instructions must be performed correctly to provide sufficient protection against touching
live parts.
UL-Certification Conditions
Field wires of control circuits can be separated from other circuits with respect to the end-use requirements.
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A9, Edition 06.2021
Attaching the Mounting Elements
Mounting plate
Mounting element
Commissioning and First Steps
11.3 Assembly
281