Alarm Of Iti (Cbema) Curve Violation; Function Description; 4.3.2 Configuration And Value View Via The User Interface - Siemens SICAM Q100 7KG95 Series Manual

Power Quality
7.3 ITI (CBEMA) Curve
[dw_ITIC value-view_evalution-tab, 1, en_US]
Figure 7-9
NOTE
i
i
The device generates ITI/CBEMA curves to the PQ report only if voltage events are detected.

Alarm of ITI (CBEMA) Curve Violation

7.3.2
7.3.2.1

Function Description

If the detected voltage violates the selected sensitivity curve, an alarm can be triggered and reported. The
device first classifies the detected voltage, and then sends the following information and report to a third–
party system, such as Desigo CC:
•
Alarm information via the Modbus protocol or IEC 61850 protocol
•
An alarm file (HTML 5) via the IEC 61850 file transfer
There are 2 Modbus registers and 1 IEC 61850 logical node for the alarm.
You can configure the alarm as a source of the binary output and the LED. For more information of the config-
uration, refer to
User Interface.
The device supports to evaluate the violation of the ITI (CBEMA)
curve).
For more information on the ITI (CBEMA) curve, refer to
7.3.2.2 Configuration and Value View via the User Interface
Value View of the ITI (CBEMA) Curve Violation
To show the sensitivity curve and the classification of the detected event in the Value view tab, proceed as
follows:
•
In the navigation window, click ITI (CBEMA) curve.
•
Configure the respective parameters according to the following table.
36 ITI, formerly known as the Computer & Business Equipment Manufacturer's Association
178
Value View Tab, ITI/CBEMA Curve

4.3.2 Configuration and Value View via the User Interface

and 4.5.2 Configuration via the
36
curve (Information Technology Industry
7.3.1.1 Function Description.
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A9, Edition 06.2021