Siemens SICAM Q100 7KG95 Series Manual page 37

Table 2-4
Parameter
Source time synchronization
Time zone offset to UTC
Daylight Saving Time switch-
over
DST offset
Start of DST
End of DST
Additional Parameters if the Source is Ethernet NTP (Modbus TCP and IEC 61850)
Primary NTP server IP Address
Secondary NTP server IP
Address
Error indication after
Additional Parameters if Source is Fieldbus
Error indication after
•
After the parameterization, click Send.
•
In the navigation window, click Activation and cancel.
•
Click Activation.
NOTE
i
i
NTP protocol: The SNTP client in the device is activated or deactivated during configuration of the time
synchronization. Ethernet NTP can be selected as Source time synchronization. Associated IP addresses
of the NTP servers can be entered.
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A9, Edition 06.2021
Settings for Time Synchronization
Default Setting
Internal
+00:00
Yes
+01:00
March
Last week
Sunday
2:00 AM
October
Last week
Sunday
3:00 AM
0.0.0.0
0.0.0.0
10 min
10 min
2.3 Time Synchronization
Setting Range
Internal
Ethernet NTP
Fieldbus
-12:00 to +13:00 (hours)
(in increments of 0.5 h)
No
Yes
0:00 to +2:00 (hours)
(in increments of 0.5 h)
January to December
First week
Second week
Third week
Fourth week
Last week
Sunday to Saturday
12:00 AM to 11:00 PM
(in increments of 1 h)
January to December
First week
Second week
Third week
Fourth week
Last week
Sunday to Saturday
12:00 AM to 11:00 PM
(in increments of 1 h)
Any
No polling of the NTP server if 0.0.0.0 is entered
Any
No polling of the NTP server if 0.0.0.0 is entered
2 min to 120 min
2 min to 120 min
Basic Functions
37