Selecting A Slide - BD FocalPoint GS User Manual

To aid in locating the right side edge, bring the slide to the top right
corner so that the top edge and right edge are in view. Then center
the right edge. This aids in visualizing the actual edge of the slide as
the clip may appear too dark to allow for slide vs. clip contrast.
If recalibration is needed while reviewing slides, Select Calibrate
When calibrating the stage, make sure that the Offset button is
disabled before proceeding. The stage calibration cannot be set
3.3

Selecting a Slide

After calibrating the stage, select the slide to be reviewed. Once the slide selection window is
displayed, select the accession number of the slide.
NOTE
NOTE
located at the bottom of the slide selection window.
NOTE
correctly with this feature enabled.
Figure 3-6 – Slide Selection window
Guided Screening
25