Double Reel Headers - MacDon Harvest Header D65 Assembly Instructions Manual

B. DOUBLE REEL HEADERS
Reposition header as follows in preparation for
assembly and set-up:
a. Choose an area with level ground.
b. Drive lifting vehicle to approach header from its
underside.
IMPORTANT
Do not lift header at this location.
This procedure is only for laying the
machine over into working position.
c. Attach chain to shipping support at center
reel arm.
CAUTION
Stand clear when lowering, as machine may
swing.
169603
UNLOADING AND ASSEMBLY
d. Back up SLOWLY while lowering forks until
e. Place 6 in. (150 mm) blocks under each end and
f.
g. Attach chain to center-link anchor on frame tube,
h. Lower header stand by pulling pin, lowering stand,
i.
12
1
3
header is just above the ground.
center of cutterbar, and lower header onto blocks.
Remove chain, and move lifting vehicle to rear of
header.
and raise rear of header so that stand can be
lowered.
and releasing pin to secure stand.
Lower header onto stand.
NOTE
If ground is soft, place a block under the
stand.
2
4
Revision B