Configuration Of I/O Signals On Sm-Din And Smart Matrix Cube - btsr MATRIX CUBE Operating Manual

Configuration of I/O Signals on SM-DIN and SMART MATRIX
CUBE
This function allows you to configure the input signals
SMART MATRIX CUBE terminal, as Normally Open (NO) or Normally Closed (NC) contacts
It also allows you to configure the RUN/STOP,
SM-DIN/DUOLOOP Board, as Normally Open (NO) or Normally Closed (NC) contacts.
For more details about the I/O signals configurable with this function, please refer to Section 1.

Configuration of I/O Signals on SM-DIN and SMART MATRIX CUBE

END RST, YARN END
Enter the
Select
Configure the signals RUN/STOP,
and STOP 1/STOP 2
window, the input signals (PRX, ZPX,
output
Normally Open (NO) or Normally Closed (NC) contacts.
To activate the save function.
SAVE
BACK
EXIT
MATRIX CUBE
SETUP
(PRX, ZPX, STC) and the relay output (OUT) of
and STOP 1/STOP 2
SETUP menu.
I/O CONFIG.
within the
OUT within the SMART MATRIX
to save the configuration,
to return to the previous screen without saving,
to return to menu.
→ I/O CONFIG
signals on the
END RST ,YARN END
SMDIN DUOLOOP
STC) and the relay
window, as
- 42 -