Id No. Setting; How To Confirm The Software Version - Fuji Electric FLR-3 Instruction Manual

4.11.7. ID No. setting

Description
 Set the ID No. for parameters (Section 4.4.1).
If ID No. is set, the number must be inputted before canceling the protection.
 To validate the protection, set the protection to "ON". (See Section 4.4.1.)
ID No. settable range: 0000 to 9999 (4-digit number)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
If you forget the ID number you set, contact us.
Operation Set "1106" as the ID No.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Set "1106" by the
▼
Press the
ENT
▼
▼
▼
▼
ESC Display the measurement mode by the
Note) To validate the protection, set the protection to "PROTECT ON".
(See Section 4.4.1.)

4.11.8. How to confirm the software version

Description
 Indicates the software version.
For actual keying, refer to the typical operation indicated below.
Operation Check the software version.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
After checking, display the measurement mode by the
ESC
key.
INF-TN3FLR-E
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS INFORMATION".
ENT
key for 8 times to display "REGISTER ID NO.".
key twice to blink on the 2nd line.
ENT
and the key.
key once to register.
ENT
――― ID NO. has been registered. ―――
ESC
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS INFORMATION".
ENT
key for 9 times to display "VER. NO.".
key and the key.
key or the
ESC
* The indicated version number is display example.
Display
MAINTENANCE MODE
RAS INFORMATION
0000000000000000
REGISTER ID NO.
REGISTER ID NO.
REGISTER ID NO.
REGISTER ID NO.
 COMPLETE 
↓
REGISTER ID NO.
0.000 %
0.000 m3/h
Display
MAINTENANCE MODE
RAS INFORMATION
0000000000000000
*
FLR****3
Ver.00A
0.000 %
0.000 m3/h
0000
1106

- 69 -