How To Validate The Range Over Output And Pulse Range Over Output - Fuji Electric Time Delta-C FSV-2 Instruction Manual

4.10.5.5. How to validate the range over output and pulse range over output

Description
 AO RANGE OVER : Select a contact output as DO1 and/or DO2when the upper limit and lower limit output are above the setting.
 PULSE RANGE OVER : Select a contact output as DO1 and/or DO2 when the total pulse output exceeds the maximum output
frequency value.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the DO1 output to "AO RANGE OVER".
(example) Also, set the contact to "ACTIVE ON".
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
* Press the
Press the
ENT
▼
Press the
▼
line.
* Press the
Press the
ENT
▼
▼
▼
▼
Press the
ENT
▼
ENT Press the ENT key once to register "ACTIVE ON"(normally off).
▼
* To select normally
▼
▼
▼
Press the
ESC
the measurement mode.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 6 times to display "DO1 OUT".
key again to display "DO2 OUT".
key once to blink the cursor.
ENT
key for 7 times to display "AO RANGE OVER" on the 2nd
key again to display "PULSE RANGE OVER".
key once to register "RANGE OVER".
ENT
――― "RANGE OVER" has been registered. ―――
key once to display "CONTACT ACTION".
ENT
on
, press the key.
――― "ACTIVE ON" has been registered. ―――
key twice and then press the
ESC
key for 3 times to enter
-60-
Display
OUTPUT SETUP
ZERO ADJUSTMENT
SET ZERO
DO1 OUT
NOT USED
DO1 OUT
NOT USED
DO1 OUT
AO RANGE OVER
DO1 OUT
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
CONTACT ACTION
ACTIVE ON
CONTACT ACTION
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
0.000 %
0.000 m3