Setting The Preset Value - Fuji Electric FLR-3 Instruction Manual

4.9.2.2. Setting the preset value

Description
 Preset value: Value which appears on the total counter when the total value has been reset.
Settable range:0 to 99999999
<Note> A resetting action simultaneously resets both forward total memory and reverse total memory.
Set the total unit beforehand in the MEASURE SETUP mode. (Refer to 4.8.3.)
When setting, stop status is set at the total mode.
Total value
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the preset value to 100m
(example) * Set the total unit beforehand.
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
* Note that, it cannot be entered on the first digit (leftmost).
Press the
▼
Press the
ENT
▼
▼
――― " TOTAL PRESET" has been registered. ―――
▼
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
▼
▼
▼
Press the
ESC
the measurement mode.
- 36 -
Reset
Reset
3
.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 5 times to display "TOTAL".
key once to display "TOTAL MODE".
ENT
key twice to display "TOTAL PRESET"
key once to display the cursor.
ENT
key for 6 times to move the cursor.
key once to display "1".
key once to register.
ENT
key for 4 times to display "TOTAL MODE".
key once to blink the cursor.
ENT
key once, and select "TOTAL RESET".
key once to register.
ENT
――― "TOTAL MODE" has been registered. ―――
key twice and then press the
ESC
Reset
OUTPUT SETUP
ZERO ADJUSTMENT
TOTAL
TOTAL MODE
TOTAL PRESET
TOTAL PRESET
TOTAL PRESET
TOTAL PRESET
TOTAL PRESET
TOTAL PRESET
TOTAL MODE
TOTAL MODE
TOTAL MODE
TOTAL MODE
TOTAL MODE
key for 3 times to enter
Preset value
Time
Display
SET ZERO
STOP
0 m3
00000000 m3
00000000 m3
00000100 m3
 COMPLETE 
↓
100 m3
STOP
STOP
TOTAL RESET
 COMPLETE 
↓
TOTAL RESET
0.000 m/s
0.000 m3/h
INF-TN3FLR-E