Setting Of Analog Input (Fixed Value) - Fuji Electric FE ZSS Instruction Manual

6.7.2 Setting of analog input (fixed value) (in case of H
Sets the fixed value to perform the calibration when the value for which the measured gas condition do not
change, or the sensors to calibrate are not provided, or the number of calibration input terminals is insuffi-
cient. When the actual value differs greatly from the setting value, analog input cannot be measured cor-
rectly.
Analog Input
GasPress.(kPa)
Gas Temp.(℃)
Gas Flow(m/s)
Ｏ２
(vol%)
Ｈ２Ｏ
(vol%)
Air Purge(kPa)
Analog Input
GasPress.(kPa)
Gas Temp.(℃)
Gas Flow(m/s)
Ｏ２
(vol%)
Ｈ２Ｏ
(vol%)
Air Purge(kPa)
Analog Input
GasPress.(kPa)
Gas Temp.(℃)
Gas Flow(m/s)
Ｏ２
(vol%)
Ｈ２Ｏ
(vol%)
Air Purge(kPa)
2007-4-1
12:00:00
Fixed 4mA 20mA
Fixed 00.00 00.00 10.00
0027 0000 0500
ＣＨ１
Fixed 02.00 00.00 20.00
Fixed 20.00 00.00 21.00
ＣＨ２ 050.0 000.0 100.0
Alarm
4mA 20mA
No
005.0 000.0 100.0
Under
( )
2007-4-1
12:00:00
Fixed 4mA 20mA
Fixed 00.00 00.00 10.00
0027 0000 0500
ＣＨ１
Fixed 02.00 00.00 20.00
Fixed 20.00 00.00 21.00
050.0 000.0 100.0
ＣＨ２
Alarm
4mA 20mA
No 005.0 000.0 100.0
Under
( ) NT
2007-4-1
12:00:00
Fixed 4mA 20mA
Fixed 00.00 00.00 10.00
0027 0000 0500
ＣＨ１
Fixed 02.00 00.00 20.00
Fixed 20.00 00.00 21.00
Fixed 050.0 000.0 100.0
Alarm
4mA 20mA
No 005.0 000.0 100.0
Under
( )
NT
Select "H O" by the
2
Press the
"Channel" setting.
Select "Fixed" by the
key, and press the
Enter the fixed value.
Change the numeric value by the
the key, and move the digits by the
key. Press the
value.
- 60 -
O)
2
key or the
key to move the cursor to
key or the
NT key.
key or
NT key to validate the set input
INZ-TN1ZSS-E
key.