Installing The Access Point On A Table - Allied Telesis TQ6000 GEN2 Installation Manual

Chapter 2: Installing the Wireless Access Point

Installing the Access Point on a Table

42
You need the following items to install the access point on a table:
TQ6000 GEN2 Access Point

One or two Ethernet cables

External AC power adapter (Optional if using PoE+. Required if not

using PoE+ or for redundant power.)
Kensington lock (optional)

Note
See "Reviewing Safety Precautions" on page 36 and "Reviewing
Installation Guidelines" on page 40 before installing the product.
Perform the following steps to install the wireless access point on a table:
1. Place the access point at the selected location on the table.
2. Connect Ethernet cables to LAN1 and LAN2 ports. Refer to
"Connecting Ethernet Cables to LAN1 and LAN2 Ports" on page 50.
3. To connect an AC power adapter to the access point, go to
"Connecting the AC Power Adapter" on page 52.
4. To install a security cable, refer to "Installing an Anti-theft Device" on
page 56.
5. To start managing the device, go to "Starting the First Management
Session" on page 57.