Weekly Maintenance Tasks; Vacuuming The Build Envelope; Monthly Maintenance Tasks; Inspecting & Replacing The Tip Wipe Brushes - Stratasys FDM Titan User Manual

FDM Titan User Guide
7. Reinstall the tip wipe assembly, cleaning if necessary, and insert the upper chute
back into the brackets along the oven wall. Make sure the assembly is locked in
the oven wall mounts to avoid damaging tips or other oven components.

Weekly Maintenance Tasks

Vacuuming the Build Envelope

Vacuum the build envelope to remove purged material and dust.

Monthly Maintenance Tasks

Inspecting & Replacing the Tip Wipe Brushes
You should inspect the tip brushes and silicone wiper once a month and change them
when excessively worn. The brushes and wiper are consumable parts that you can
order. See "Consumable Orders" on page 1-1 for more information.
WARNING: The oven, waste chutes, and tip wiper components may be
1. Allow the tip wipe assembly to cool
to room temperature.
2. Remove the tip wipe assembly from
the purge bucket by removing the
two screws and pulling the pull ring.
3. Loosen and remove the outer brush
retaining screws from the wiper
mount.
4. Slide the worn brushes out the end
of the wiper.
5. Install a new brush.
6. Reinstall the brush retaining screws.
7. Repeat the process for the other
brush, if required.
8. Reinstall the pull ring bracket with the two screws.

Replacing the Silicone Wiper

Inspect and replace if necessary.
1. Allow the tip wipe assembly to cool to room temperature.
HOT!!! Use safety gloves and safety sleeves. if removing the
tip wipe assembly from a hot oven.
Maintaining the Machine
Tip Wipe
Assembly
Silicone
wiper
Brush
Pull Ring
8 - 3