Tip Identification - Stratasys Fortus 360mc User Manual

a.ABS-M30/M30i model materials can use SR-20 or SR -30 support materials.
Use the T12SR20 tip for SR-20 material (regardless of model tip size) and use
the T12SR30 tip for SR-30 material (regardless of model tip size).
PC-ABS and ABSi model material requires the use of SR-20 support material
& the T12SR20 support tip (regardless of model tip size).
ASA model material uses SR-30 support material. A T12SR30 support tip
should be used regardless of model material tip size.
PC model material uses PC_S support material. Support tip matches model
tip size for T16 and T12. PC T20 uses a T16 support tip.
Ultem* 9085 model material uses ULT_S support material.
PPSF model material uses PPSF_S support material.Support tip size matches
model tip size.
Nylon 12 model material uses SR-110 support material. A T12SR100 support
tip should be used regardless of model material tip size.
b.Tip Life is directly related to the amount of material that passes through
the tip. The amounts listed above are approximates of how much material
will pass through a tip before the tip will need to be replaced. Because
other factors can affect tip life, the material amounts are only
approximates.

Tip Identification

All model and
support tips are
interchangeable -
EXCEPT for the
Soluble Release
support tip.
Tip size is imprinted
on the top-side of
plate
(T10, T12, T16, T20).
Figure 3-8: Tip Identification
3-12
The Soluble
Release support tip
is shorter than the
standard tips.
Tip size is imprinted
on the top side of
the plate (T12SR20,
T12SR30, T12SR100).