XY and Z Tip Offset - Manual Start
Note: If the support layer is not centered on the model layer,
an XY and Z Offset should be performed.
Note: Perform an
Offset) - Manual Start" on page 6-9
1.
Build the Calibration Model.
A.
B.
C.
2.
At completion of the calibration model, 'read' the model and calibrate the
system by following paragraphs 2. through 5. from
Calibration" on page
"Auto Tip-Tip Calibration (AutoCal Tip
From the Main Menu select Operator Control and press Enter.
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
Select Calibrate and press Enter.
Unlock Door <E>
Load/Unload Mtl..
Change Tips/Mtl..
>Calibrate..
Select Calibration Job and press Enter.
Set Z Stage Zero..
AutoCal Tips <E>
Tip Offset Value..
AutoHome XYZ <E>
6-2.
before XY and Z Offset.
|*Tips: Model T16
|*
Support T16
| Temp Control..
| Move Head/Stage..
|>Calibration Job <E>
6-10
"XY and Z Tip Offset