Operation Procedures - YASKAWA E-V Series User Manual

8.6.2 Operation Procedures

(1)
Operating from the Digital Operator
The procedure for operating from the digital operator is shown below.
Step Display After Operation
A . E C 0
F n 0 4 3 S O M P r m I n i t
1
F n 0 4 4 S O M A l m C l r
F n 0 8 0 P o l e D e t e c t
F n 2 0 0 T u n e L v l S e t
A . E C 0
S a f e t y
2
S e t u p A l a r m C l r
S t a r t
R e t u r n : [ S E T ]
A . E C 0
S a f e t y
3
S e t u p A l a r m C l r
S t a r t
R e t u r n : [ S E T ]
A . E C 0
F n 0 4 3 S O M P r m I n i t
4
F n 0 4 4 S O M A l m C l r
F n 0 8 0 P o l e D e t e c t
F n 2 0 0 T u n e L v l S e t
Note: If alarm A.EB0 (Safety Module: System Malfunction) occurs during operation, "NO-OP" is displayed in the status
display and "SYSTEM ERROR" flashes on the screen. Press the
function mode and make the settings again.
Keys
− F U N C T I O N −
: [ D A T A ]
: [ D A T A ]
− F U N C T I O N −
8.6 Safety Option Module Setup Alarm Clear (Fn044)
Operation
Press the Key to display the main menu of utility
function mode and select Fn044 using the
Key.
Press the Key to display the setup alarm clear
execution screen.
Note 1. If the cause of the Safety Module:
Confirmation Alarm (A.EC0) is cleared:
"NO-OP" is displayed in the status display
for approx. one second.
2. If the Key is pressed, the display
returns to the main menu of utility function
mode.
Press the Key to clear the Safety Module:
Confirmation Alarm. "Processing" flashes on the
menu display while the alarm is being cleared. When
the alarm has been cleared, "DONE" flashes in the
status display for approx. one second.
Note: If an attempt to clear the alarm fails: 
"ERROR" flashes in the status display for
approx. one second, and the display returns to
the setup alarm clear execution screen. Try to
perform the operation again.
Press the Key to return to the main menu of
utility function mode.
Key to display the main menu of utility
or
8-15