Norwood The Grain Handler 8 Operator's Manual page 75

SERVICE PROCEDURE:
Installation:
4. After measuring and finding the center, place a mark on
the sweep auger back board plate.
5. Locate the closest support bracket to the mark.
IMPORTANT
If the support bracket at the center of the sweep auger is
over a hopper, then use the next support bracket further
away from the center of the bin.
Fig. # 3-84)
Fig. # 3-83 Support Bracket Too Close To Hopper
Hopper
Fig. # 3-84 Determining Installation Location
6. There are 2 different types of support brackets, one with
holes and one without holes. All new Power Sweeps use
the support bracket with holes. If you have the support
brackets without holes, proceed to step # 7, if you have
the support bracket without holes, then proceed to step
# 10.
(See Fig. # 3-85) (See Fig. # 3-86)
3 - INSTALLATION
(See Fig. # 3-83) (See
Support
Bracket
Hopper
Support
Bracket
3-35
Fig. # 3-85 Support Bracket Without Holes
Fig. # 3-86 Support Bracket With Holes
Support
Bracket
Without
Holes
Support
Bracket With
Holes