17. Adjust the "Motor Mount Belt Tension Lever" 57 so
the "Motor Mount Base" 55 is level or parallel with the
top of the U-Trough.
Fig. # 3-54 Motor Mount Base Tension
18. Support the "Electric Motor" 58 , and install to the "Mo-
tor Mount Base" 55 . Secure with (Qty. 4) "3/8-16"X 2
Carriage Bolts 59 , "3/8 Flat Washers" 60 , & 3/8-16
Nylock Nuts" 61 .
(See Fig. # 3-55)
58
61
60
55
Fig. # 3-55 Mounting Electric Motor To MM Base
(See Fig. # 3-54)
55
57
59
3 - INSTALLATION
19. Install the "Upper Sheave" 62 , & "Keystock" 63 onto
the "Electric Motor" 58 shaft. Do not tighten the set-
screws at this time.
20. Install the "V-Belts" 58 . If necessary adjust the "Motor
Mount Belt Tension Lever"
slack to install belts.
3-22
(See Fig. # 3-56)
58
Fig. # 3-56 Install Upper Sheave
(See Fig. # 3-54)
(See Fig. # 3-57)
58
Fig. # 3-57 Install V-Belts
63
62
to give