Norwood The Grain Handler 8 Operator's Manual page 71

13. Mesh the "Auger Flighting" 15 together and make sure
you have at least 1/2" of engagement on the mounting
bracket. Tighten the (Qty. 4) "3/8"-16 x 1-3/4 Bolts" 6 to
31 ft-lbs to the "Backboard Extension" 7 temporarily.
Do not tighten the jam nuts at this moment.
3-76)
6
6
Fig. # 3-76 Installing New Standard Drive Wheel Flighting
Extension (Step 3)
12. Lower the Power Sweep assembly to the grain bin floor.
13. Remove the "Lifting Strap".
3 - INSTALLATION
(See Fig. #
15
7
1/2"
14. Loosen the (Qty. 4) "3/8"-16 x 1-3/4 Bolts" 6 and adjust
the "Standard Drive Wheel & Flight Extension" 14
so that the outside face of the "Drive Wheel" 17 is 6.0"
(152.4mm) from the inside of the "Grain Bin Wall" 16 .
(See Fig. # 3-77)
6.0 "
6
Fig. # 3-77 Installing New Standard Drive Wheel Flighting
Extension (Step 4)
15. Tighten the (Qty. 4) "3/8"-16 x 1-3/4 Bolts" snug.
Fig. # 3-77)
3-31
6
(See